5/26/2023 0 Comments Reflow machines![]() The reflow profile was limited to the vapour phase fluid medium used and the time in the tank. They also had limited temperature profiles available. Early machines lost a lot of the vapour phase fluid medium in the process making them environmentally unfriendly and also unhealthy. VPR ovens have been around for a long time, but they fell out of favour. This process provides a high heat transfer and ensures very little temperature difference occurs between components of different thermal mass. Unlike Convection Reflow machines, which use hot air to apply heat to the PCB as it travels through a conveyor belt, Vapour Phase machines use the latent heat of condensation from a vapour layer, which is created by boiling a liquid at 235C. ![]() This takes time, and risks damaging the test board which may be precious if it is a small run. Profiling is where you monitor the temperature rise through an HACR oven with a thermocouple attached to the test PCB assembly. These change the rate at which heat is conducted from hot air in the oven. Hot air convection reflow (HACR) profiles are influenced by the thermal mass of the PCB and its components, and the “colour” of the components. Convection Reflow ProfilesĮvery PCB assembly may need a unique reflow profile and Convection Reflow as a method of SMT reflow soldering is not always suitable. We wanted to improve the efficiency of our SMD process as the current set up was causing delays and production bottlenecks, and Vapour Phase ovens have proven to be the best investment to eliminate these hold ups. In our search for a Surface Mount Device (SMD) Reflow System that would not require constant profiling every time we ran a new job, Newbury Electronics was reintroduced to Vapour Phase Reflow machines. ![]() Aug 30th 2019 Why We’re Using A Vapour Phase Reflow Machine Why Vapour Phase Reflow? ![]()
0 Comments
Leave a Reply. |